Specifications
ITEM NO:E945
Power Supply: 220V – 240V(50Hz)
Dehumidify Capacity: 18L/D
Power Consumption: 320W
Capacity if water tank: Operation stops approx.4.5L
Net weight: 12kg
Dimensions: 378(L)×185(W)×582(H)mm
Room Temperature: 5℃ - 35℃
Accessories: Anti bacteria Air Clean Filer

operation and performance

The evaporator with in the dehumidifier frosts during dehumidifting operation at room temperature of approx. 15℃ or less. For removing frost the defrosting devices works auromatically at an interval of approx. 30 minutes or mote (for duration of approx. 5 minutes).

Both the dehumidifying function and the air cleaning function stop during the defrosting operation.
Do not disconnect the plug of the unit or turn off the unit during the defrosting operation.

This dehumidifier is not suitable for keeping the humidity very low (approx.50% or less)

This dehumidifier is designed to remove uncomfortable humidity in daily life and to use for auxiliary drying of washed clothes indoors. This is not suitable for keeping the humidity very low.

Room temperature rises during the operation.
This dehumidifier does not have cooling function. It produces heat during the operation and room temperature rises by 1℃ to 4℃. The temperature gets higher while it is operated in a closet, or the like. Furthermore, room temperature rises because doors and windows are closed and heat is produced from other appliances in the room and the sun radiation.

Key words:"modeling clay"、"oven-bake clay"、 "polymer clay"
E944G

E944F

E944C

E944B

E944H

E944D

E944A

E944E

E944H

key word：Aroma corbeil,basket,aroma,large-size,middle-size,small-size.
E943A,E943B,E943C,E943D,E943F,E943G,E943H
E943I,E943J,E943K,E943L,E943M,E943N

Foot spa-E817-B

E817-B describe E817-B ion Cleansing detox SIZE: 49*40*26CM BOX SIZE: 44*30*53CM CARTONSIZE: 91*63*56CM/4 sets UNIT N.W.:3.2KG UNIT G.W.:4.5KG CARTON G.W.:20KG This product processor consists of 2 main portions: a main box and the array. The main box contains 5 buttons and 4 display panels. The 5 buttons are: 1. mode select 2. time up 3. time down 4. start / stop 5. on / off The 4 panels are: 1. mode (4 modes for selection) 2. work pressure (voltage) 3. work electricity(ampere) 4. Time (treatment time in min)

Operation procedures:
1.Before coming into use, insert the power cord and the array into the corresponding jacks in chassis, place the array into    a basin filled with water, and then turn the power on and press on and the ON/OFF button.
2.The time and the work pressure will show the accumulative treatment time used, the WORK PRESSURE will indicate the    NO. of hours and the TIME will indicate the NO. of minutes used. When the total amount of time used is up to 60 min,    there will be an increase in one hour shown in the WORK PRESSURE panel. Example, if the total accumulative time used    is one hour twenty minutes, the work pressure panel and the time panel will display the NO.002 and 20 respectively.
3.When the accumulative time showing step is completed, the whole device will back to the “ready” state of operation with
   I. The TIME shows at 30 min, the predetermined treatment time.
   II. The MODE shows at 1, that is mode NO.1,the pre-determined treatment mode, There are 4 modes for selection with        mode NO. 4 the strongest and NO.1 is the weakest among the 4 modes.
   III. The WORK PRESSURE shows the word “OFF”, a ready state.
   IV. The WORK ELECTRICITY shows at “0.00”, a ready state.
4.We could now start detoxification by pressing the “STRAT/STOP” button.
   I. The WORK PRESSURE will change from “OFF” to “12.0” which means the devices is under 12 voltage (V).
   II. The WORK ELECTRICITY will change fluctuate in between 0.00 and 5.00 ampere (A). And for BEST detoxification to        take place, the best ampere used should be controlled in between 3.00 and 4.20A. It could be done by adding suitable        amount of “salt water” to make the ampere reach the desirable reading, 3.00~ 4.20A.